Parts undersize in both X & Y directions
Posted: Fri May 05, 2017 4:00 pm
Hello,
Have a Max V2 for over two years, great machine. I'm having to rescale prints from 1.0 to 1.063 in both X & Y directions to get print close to .stl model in size. What can I do to correct for this condition to eliminate rescaling? Z dimensions are within a few thou. I'll re-flash the firmware if need be. I'm using Simplify3D for slicing.
Thanks,
Cris
Have a Max V2 for over two years, great machine. I'm having to rescale prints from 1.0 to 1.063 in both X & Y directions to get print close to .stl model in size. What can I do to correct for this condition to eliminate rescaling? Z dimensions are within a few thou. I'll re-flash the firmware if need be. I'm using Simplify3D for slicing.
Thanks,
Cris