Page 1 of 1
Suggestions for PDF instructions
Posted: Wed Jan 02, 2013 7:25 pm
by jesse
Instructions:
http://www.geneb.org/rostock-max/rostoc ... manual.pdf
One set of end stop wires (black and white) is longer than the other two sets by about a foot.
The long set of wires goes opposite the rambo board.
Re: Suggestions for PDF instructions
Posted: Wed Jan 02, 2013 7:33 pm
by jesse
"It should just take a tad more than their own weight to make them "drop" when you hold them horizontally.".
That explains the feel of it a little better.
Source:
http://reprap.org/wiki/Rostock_MAX, Step 4
Re: Suggestions for PDF instructions
Posted: Thu Jan 03, 2013 9:07 am
by geneb
Thanks, I'll get the PDF updated as soon as I can.
g.
Re: Suggestions for PDF instructions
Posted: Thu Jan 03, 2013 9:43 pm
by jesse
Steve responded to my email to explain how the thermistor on the Onyx heated build platform is wired.
Originally I was going to solder the thermistor to the top similar to the standard heated bed.
The photos below show that the thermistor is supposed to be soldered underneath the Onyx to the surface pads.
[img]
http://i.imgur.com/GbH0W.jpg[/img]
[img]
http://i.imgur.com/YuQ0a.jpg[/img]
Re: Suggestions for PDF instructions
Posted: Thu Jan 03, 2013 9:45 pm
by johnoly99
Jesse, john here. Yep, that's how it goes.