Welcome to the SeeMeCNC Community

I have been having problems with bed adhesion for the last few weeks, on troubleshooting today after a calibration run I noticed that the bed does not want to heat up anymore.

I have noticed that when turning heat (for the bed) on, the LED does not flicker anymore, however the thermistor is reading temperature still.

I am assuming this is most likely a blown fuse, I have not taken the bed apart because I wanted to get some insight before I went down that route. What is the location/code for this on the board? Any other troubleshooting tips to figure this out?

Thanks.

The fuse is an automotive fuse.

It is the big one that sticks out. Can't miss it.

Check the cables aswell.

Checked the fuse...I think I found the issue....

[img]http://i.imgur.com/pKx5Wf3.jpg?1[/img]

I had the Exact same problem.

Check out my thread for a fix.