Help with extruder wire resistance
Posted: Thu Sep 24, 2015 5:19 pm
I'm hoping someone could help me with checking the wiring resistance for my extruder wires.
The temp will not climb above 224 after printer has been on for 10-15 minutes. While printing, the temp drops to 222 (at first) and hovers there, then steps down after a while to 217-218 (and hovers there, no matter what I have the temp set to).
Here is a pic of my meter...will this suffice? and what do I set it on, if so, and what reading am I hoping for?
Thanx in advance!
The temp will not climb above 224 after printer has been on for 10-15 minutes. While printing, the temp drops to 222 (at first) and hovers there, then steps down after a while to 217-218 (and hovers there, no matter what I have the temp set to).
Here is a pic of my meter...will this suffice? and what do I set it on, if so, and what reading am I hoping for?
Thanx in advance!