Welcome to the SeeMeCNC Community

I'm interested in learning more about duel extruders. From what I gather you basically modify the current hotend to fit two exturders. I'm sure I can manage getting all that together, but where do you get the software to run this type of setup, or is that something you also have to experiment with? Does anyone have this setup?
Any advice is welcome, I'm looking for a shove in the right direction.

Thank you,
Ziggey

This must be the top of the week... wow lots of posts lately! DO a search on the forum.



Also,
[img]http://www.ahmedv.com/wp/wp-content/upl ... 20duel.jpg[/img]

JFettig wrote:This must be the top of the week... wow lots of posts lately! DO a search on the forum.



Also,
[img]http://www.ahmedv.com/wp/wp-content/upl ... 20duel.jpg[/img]

hahah that was mean!

I for one would love to see dueling hot ends!

And yes..A bit mean...