Welcome to the SeeMeCNC Community

We just received dampers from Astrosyn.

Not posted on our site yet, but they're going to be $35/set which includes the longer hardware needed.

SeeMe forum members get $5 off for the next week.

They'll be listed at MatterHackers.com

I'll post a discount code as soon as they're on the store.

Life is too short to have noisy printers! It'll be the best $30 you ever spent.

I can not even dream of printing without these! Glad to see you guys will stock them and more folks will know the joy of a reduced noise Max!

$5 discount code for forum members - EAOMSZ

http://www.matterhackers.com/store/prin ... ers-3-pack

I think you mean shorter hardware. They require shorter hardware, not longer, to install properly.

Yep. The shorter screws go into the stepper itself.

I did find that I'm going to have to do a full re-cal after installing the dampers. Not sure why.

g.