Wall thickness...
Posted: Wed May 14, 2014 9:30 pm
I have been experimenting more and more on some of the Slic3r settings and I
think I'm getting a little closer to better prints but there is one thing I'm not sure of.
I notice the fill pattern on 2 sides of the plot but the more or less solid fill on the other
two sides. I would imagine the settings made for the side wall would be the same on
all four sides. Wall and bottom = 2 mm.
Thanks, Norm77
think I'm getting a little closer to better prints but there is one thing I'm not sure of.
I notice the fill pattern on 2 sides of the plot but the more or less solid fill on the other
two sides. I would imagine the settings made for the side wall would be the same on
all four sides. Wall and bottom = 2 mm.
Thanks, Norm77