Have a look around and join today!
https://images.seemecnc.com/
There is a max temp setting in the configuration.h of your firmware which you would need to increase then upload the firmware to themrbdrm wrote:Hi
i have installed E3D and i don't know where to start to increase the temp limit on the hot end. searched for a guide with no luck.
can i change it from EEPROM configuration in repetier host?
You should just modify the setting in configuration.h then upload. Make sure that the maxtemp value you are changingmrbdrm wrote:ok
is there something i need to do before that? backup? or simply modify the maxtemp value then upload?
thank youEaglezsoar wrote:You should just modify the setting in configuration.h then upload. Make sure that the maxtemp value you are changingmrbdrm wrote:ok
is there something i need to do before that? backup? or simply modify the maxtemp value then upload?
is for the extruder.
That is one of the problems with going to the E3D and I don't know if anyone ever created a layer fan that works withoutmrbdrm wrote:thank youEaglezsoar wrote:You should just modify the setting in configuration.h then upload. Make sure that the maxtemp value you are changingmrbdrm wrote:ok
is there something i need to do before that? backup? or simply modify the maxtemp value then upload?
is for the extruder.
i have done it and everything is good
what layer fan mount you guys recommend with this mount http://www.thingiverse.com/thing:137140 from 626Pilot
the stock one is lower than the nozzle now.
That one looks great! I don't know how I missed that one but I'm glad you did not.mrbdrm wrote:how about this http://www.thingiverse.com/thing:304011