Page 1 of 1
Hello : KC from Indiana
Posted: Sat May 03, 2014 6:25 am
by KConley
Just purchased the Orion 3D printer, very impressed with it. But none the less I have a lot to learn with the development of being able to print something on my own seem very overwhelming at this point. Any suggestions or websites that does a step by step procedure of this from the drawing to slicing it and to putting on a sd card and to print?
Re: Hello : KC from Indiana
Posted: Sat May 03, 2014 9:07 am
by Eaglezsoar
KConley wrote:Just purchased the Orion 3D printer, very impressed with it. But none the less I have a lot to learn with the development of being able to print something on my own seem very overwhelming at this point. Any suggestions or websites that does a step by step procedure of this from the drawing to slicing it and to putting on a sd card and to print?
Download the 2nd edition of the Orion Users Manual, the last chapters tell you most of what you are looking for, the link is here:
http://download.seemecnc.com/orion/Orio ... -2ndEd.pdf