Page 1 of 1
Demon Head
Posted: Wed Mar 05, 2014 10:39 pm
by Toyguy
Printing this guy from Thingiverse for my demo at work next week. Currently at 97% after 14 hours.
[img]
http://i243.photobucket.com/albums/ff27 ... 2b5cc8.jpg[/img]
Re: Demon Head
Posted: Wed Mar 05, 2014 10:43 pm
by Tinyhead
That's wicked! Worked well without support for those horns! And do you have a link for the file? Can't seem to find that one at quick glance on thingiverse.
Re: Demon Head
Posted: Wed Mar 05, 2014 11:14 pm
by Toyguy
Yeah, I was surprised it actually printed with no support. I printed it at .1mm layer height, so the detail is quite good. I think it will make an impressive display piece for my demo. Here's the link:
http://www.thingiverse.com/thing:224878