Welcome to the SeeMeCNC Community

ok, so i made this gear. it's look's cool....
it took me about an hour to clean the raft and the brim....
and after all this job it's moving
my only problem with my print is ( i think) that i didn't increase the retraction, so if you look close yo can see that it make the balls not that round which make the gear move a little hard...
the stl attache here as well.... good luck trying to print it and i will love to see what you print

Orenfor wrote:ok, so i made this gear. it's look's cool....
it took me about an hour to clean the raft and the brim....
and after all this job it's moving
my only problem with my print is ( i think) that i didn't increase the retraction, so if you look close yo can see that it make the balls not that round which make the gear move a little hard...
the stl attache here as well.... good luck trying to print it and i will love to see what you print

Actually the print you made looks quite good for such a difficult print due to it's complexity with all of those round balls.
The fact that it moves at all is a surprise to me, I would have thought that everything would be joined together.