Welcome to the SeeMeCNC Community

[img]https://lh5.googleusercontent.com/-8501 ... 125038.jpg[/img]

nylon 645 vase big and little

[img]https://lh3.googleusercontent.com/-KRgs ... 211934.jpg[/img]

big one has 3 perimeters and the lil guy has 1

What do have there electronic wise?

LED Ring
http://www.adafruit.com/products/1463

Arduino NANO ripoff from sainsmart
http://www.amazon.com/gp/product/B00CJ7 ... UTF8&psc=1

[img]https://lh6.googleusercontent.com/-K2GN ... 123158.jpg[/img]

[img]https://lh4.googleusercontent.com/-r0bj ... 130454.jpg[/img]

Could you share where you found the .stl for the planes?
They look pretty good.

the repaired file is the whole airframe.

the 1-4 files are sliced in a way for easy printing

https://drive.google.com/folderview?id= ... sp=sharing

bubbasnow wrote:the repaired file is the whole airframe.

the 1-4 files are sliced in a way for easy printing

https://drive.google.com/folderview?id= ... sp=sharing

Thanks for the files Tylor.

Very nice use of a dental floss tool in the first pic, like it alot! LOL

[img]https://lh4.googleusercontent.com/-ix3- ... 130151.jpg[/img]

[img]https://lh6.googleusercontent.com/-FC_j ... 130205.jpg[/img]
Rammus from league of legends

That's awesome, the only model I had downloaded was cho'gath and I haven't done that yet because of the tons of support it would require.

Ill try cho next with these settings and let you know if i have any luck


UPDATE** Just KISS'd it, @1.5 x scale its an 18 hr print... Ill hit the go button tomorrow AM

update to the update** i did just 1x scale for 7 hours... now i gotta pick the support out

[img]https://lh4.googleusercontent.com/-IVEO ... 180643.jpg[/img]

[img]https://lh3.googleusercontent.com/-M5jC ... 180635.jpg[/img]

[img]https://lh4.googleusercontent.com/-JXqh ... 034835.jpg[/img]

he died

You have inspired me to try it as well. My first attempt met a similar fate, I will say Ultra level supports in kisslicer were not the way to go. I may have to step it up to 2x the model size because his legs are just so damn tiny at some points. Learning alot about supports and it reaffirmed why I was avoiding it for awhile

lordbinky wrote:You have inspired me to try it as well. My first attempt met a similar fate, I will say Ultra level supports in kisslicer were not the way to go. I may have to step it up to 2x the model size because his legs are just so damn tiny at some points. Learning alot about supports and it reaffirmed why I was avoiding it for awhile

The stl loads in blender pretty well for my second attempt in addition to a scale up I think I will increase the radius of his legs and arms