Welcome to the SeeMeCNC Community

Is there a fan mount for the SeeMeCNC 25x25x10mm fan to attach to a J-head?

fan: http://shop.seemecnc.com/FAN-12VDC-25mm ... egoryId=-1

jhead: http://reprap.me/epages/reprap_nu_41490 ... -Head-0001

http://forum.seemecnc.com/viewtopic.php ... 664#p14664
This is a discussion about the Jhead and he has built a custom made fan mount,
I don't know if it would work for you but he has suppled the STL file.

Eaglezsoar, Thanks for the tip. This gave me an excuse to buy KISSlicer Pro so I could open the multiple images that are contained in the FANHOLD stl. I was thinking about going Pro anyway and don't mind supporting Jonathan Dummer a little bit with all the work he put into KISSlicer. Got my best prints so far out of the free version I downloaded. The Pro can only be better right?