Calibrating Z-Heights/ Recalibrating
Posted: Sat Jun 08, 2013 2:05 pm
Because of a lack of measuring tools, I was really frustrated about getting accurate measurements - especially when measuring Z-heights.
This 24" Combo Square ended up working pretty well for me.
http://www.harborfreight.com/24-inch-co ... 96791.html
I used the square to get the protractor to 90 degrees and then slid it back down to the end. I took measurements at three points around the head's circumference and averaged them as the Z-height to enter in on @Geneb's page 149 - Max Length settings.
[img]http://www.harborfreight.com/media/cata ... _13053.jpg[/img]
This 24" Combo Square ended up working pretty well for me.
http://www.harborfreight.com/24-inch-co ... 96791.html
I used the square to get the protractor to 90 degrees and then slid it back down to the end. I took measurements at three points around the head's circumference and averaged them as the Z-height to enter in on @Geneb's page 149 - Max Length settings.
[img]http://www.harborfreight.com/media/cata ... _13053.jpg[/img]