Welcome to the SeeMeCNC Community

I just printed my first 3DBenchy with Gcode.
Next step, I want to use a slicing software. I chose/downloaded Cura 3.2 and the install was full of problems.
I finally managed Cura to load and now, I need to select my printer. I DON"T SEE my Rostock V3.2 or any of SeeMeCNC models at all.
I guess I could use the Custom settings but don't know all the settings.
I am stuck.....I would appreciate a little help?

Here's the cure to those ills: https://seemecnc.dozuki.com/Guide/Setti ... 87?lang=en

FYI, when version Cura 3.3 is released it will include selections for SeeMeCNC's printers.

g.

Thanks you SO much for the Cura printer configuration info for Rostock 3.2. Now, I have Mattercontrol AND CURA slicing away.

You're welcome!

g.