Welcome to the SeeMeCNC Community

Had a 20ish hour print going and left it for the last 6 or so over night. When I got up in the morning it looks like it just gave up with about an hour to go. The print stops dead with about half an inch of model needing to be printed. I exported the console (not sure if that resets per print or what? but I didn't try anything since this one failed)

I see alot of coordinate type output followed by this. I don't see any obvious error message as to why it wouldn't have finished. Am I just missing something?

->N1330991 M140 S0*101 [58259.837]
<-TargetExtr0:0 [58260.540]
<- [58260.540]
<-Printed filament:841.71m Printing time:7 days 0 hours 52 min [58260.578]
<- [58260.578]
<-ok 1330991 [58260.578]
<- [58260.578]
<-TargetExtr0:0 [58260.578]
<- [58260.578]
<-TargetBed:0 [58260.578]
<- [58260.578]
->N1330992 M105*36 [58260.580]
<-ok 1330992 [58260.585]
<- [58260.585]
<-T:199.72 B:60.31 B@:52 @:126 [58260.585]
<- [58260.585]
->N1330993 G1 X21.4 Y19.5 Z158.5 E8814.351 F12000*80 [58260.589]
<-ok 1330993 [58260.594]
<- [58260.594]
->N1330994 G90*21 [58260.595]
<-ok 1330994 [58260.601]
<- [58260.601]
->N1330995 G28*23 [58260.603]
<-ok 1330995 [58260.610]
<- [58260.610]
->N1330996 M114*32 [58260.612]
<-ok 1330996 [58260.701]
<- [58260.701]
<-X:0.00 Y:0.00 Z:382.88 E:8814.35 [58263.616]
<- [58263.616]
->N1330997 M105*33 [58263.618]
<-ok 1330997 [58263.625]
<- [58263.625]
<-T:199.86 B:60.31 B@:0 @:0 [58263.625]
<- [58263.626]
->N1330998 M84*22 [58263.627]
<-ok 1330998 [58263.633]
<- [58263.633]
->Communication State: FinishedPrint

->M84
<-ok 1330998
<-
<-wait
<-
->M105

<-ok 1330998
<-
<-T:199.72 B:60.31 B@:0 @:0
<-
<-wait
<-
<-wait
<-
->M105

<-ok 1330998
<-
<-T:199.44 B:60.31 B@:0 @:0
<-
<-wait
<-
<-wait
<-
->M105

...

->M105
->M105
->M105
->M105