Welcome to the SeeMeCNC Community

I am considering getting an undermount from 713Maker for my HE280 and a Berdair kit (when they are available) in order to reduce the size of my print head diameter for sequential printing of multiple parts as well as more stable hot end/bed temperatures due to more appropriate cooling.

Anything I should think of before going down this path?

Thanks,
-Dwight

Also, what is a good LED light ring that would go with this?

Tricklaser has a nice set

http://www.tricklaser.com/LED-Light-Rin ... D-RING.htm

Personally though, I didn't see a point in having the leds right at the print head so I just got some ubdercabinet led pick lights and put them on the underside of the top.

The berdAir is great, but I'd buy extra of the round pipes, as bending them takes a bit of a learning curve...