Page 1 of 1
Problem since updating Matter Control
Posted: Mon Jan 30, 2017 4:27 pm
by 92869
Right after updating Matter Control my Rostock Max V2 disconnects before the heated bed reaches temperature. Using ABS with a bed temp of 110. Upon opening Matter Control I get an error message: ....accelerometer send i2c error.... Never got this message until the update.
Re: Problem since updating Matter Control
Posted: Mon Jan 30, 2017 6:39 pm
by 92869
Appears most recent update of MC is written for features found on the Max V3 printer i.e. leveling probe. I've bought the update features and will install them but for now simply going back to the previous version of MC.
Re: Problem since updating Matter Control
Posted: Tue Jan 31, 2017 9:40 am
by geneb
MatterControl is *completely* independent of the printer it's driving. There's no special "v3" features in it at all. If you're getting the I2C error, then you've upgraded the firmware on your v2 - the error is non-fatal for those machines not equipped with the probe board.
g.