Welcome to the SeeMeCNC Community

Hello all,

Today I turned on my printer to an odd problem. When I run G28/G29 and the printer is homing. it can sometimes do an odd mid movement stutter and it has even once rebooted the RAMBo during such an event.

Anyone have any advice where I should start looking for the problem and what the problem might be?

Sincerely,
Javier.

Hi Javier

I had intermittent issues when calibrating & traced it to the hot end whip plug moving around as the whip & Bowden tube were flexing. Because calibration moves the head to extreme positions it can work loose.
I strapped mine on with tape or there's a whip clip on Repables http://repables.com/r/811/.

Z