Welcome to the SeeMeCNC Community

hello to everyone again, i have gone from my v1 acrylic to a up todate v2 (i hope) lol
i have made a few calb blocks etc and gone into making a few other bits but seem to be getting the same issue with the print quality.
i am using abs 1.75mm noz temp is 225 and bed 85
but there are always lines in the print.

any help would be great thanks

Can you say "Over extrusion"! Check your nozzle size and make sure the right nozzle size is selected in your slicer. Do a search for extruder calibration. It will help immensely and is pretty easy to do.

Check this guide out - https://www.simplify3d.com/support/prin ... eshooting/