New layer cooling fan & shroud for Rostock Max V2
Posted: Wed Jul 06, 2016 6:56 am
I tried to find something like this with the search function in the forum, but didn't succeed. So here we are:
A new cooling fan and shroud for my Rostock Max V2. I'm very satisfied with the performance - as cooling is much better than the stock fan. Hence my prints with PLA come out great, especially then ones with tiny structures:
http://www.thingiverse.com/thing:1656107
Let me know what you think.
The only caveat is that the Stock hot end gets cooled down when running at 100% fan speed. 60% is a good value for me, where 100% with the stock fan wasn't enough. I think I will replace the stock hot end to a E3D soon.
*John*
A new cooling fan and shroud for my Rostock Max V2. I'm very satisfied with the performance - as cooling is much better than the stock fan. Hence my prints with PLA come out great, especially then ones with tiny structures:
http://www.thingiverse.com/thing:1656107
Let me know what you think.
The only caveat is that the Stock hot end gets cooled down when running at 100% fan speed. 60% is a good value for me, where 100% with the stock fan wasn't enough. I think I will replace the stock hot end to a E3D soon.
*John*