Heated bed does not heat.

[velocilobster]

I have been having problems with bed adhesion for the last few weeks, on troubleshooting today after a calibration run I noticed that the bed does not want to heat up anymore.

I have noticed that when turning heat (for the bed) on, the LED does not flicker anymore, however the thermistor is reading temperature still.

I am assuming this is most likely a blown fuse, I have not taken the bed apart because I wanted to get some insight before I went down that route. What is the location/code for this on the board? Any other troubleshooting tips to figure this out?

Thanks.

[teoman]

The fuse is an automotive fuse.

It is the big one that sticks out. Can't miss it.

Check the cables aswell.

[velocilobster]

Checked the fuse...I think I found the issue....

[img]http://i.imgur.com/pKx5Wf3.jpg?1[/img]

[teoman]

I had the Exact same problem.

Check out my thread for a fix.