I need to buy more of the pin connectors for the motors, I tried radio shack. can someone recommend a source and the tool to put them on? What is the proper name for them anyway?
Thanks Bill
Source for pin connectors and tool?
-
foshon
- Printmaster!
- Posts: 600
- Joined: Fri Mar 08, 2013 3:05 pm
- Location: Just to the right of SeeMeCNC
Re: Source for pin connectors and tool?
Double check but, I believe this is your huckleberry:
https://www.jameco.com/webapp/wcs/store ... isplayView
And for a tool, I use http://www.ebay.com/itm/PA-20-Crimp-too ... 0641824592
https://www.jameco.com/webapp/wcs/store ... isplayView
And for a tool, I use http://www.ebay.com/itm/PA-20-Crimp-too ... 0641824592
Purple = sarcasm
Please do a board search before posting your question, many have been answered with very time consuming detail already.
Please do a board search before posting your question, many have been answered with very time consuming detail already.
Re: Source for pin connectors and tool?
I got my crimp connector from Amazon - here http://www.amazon.com/HT-225D-Cycle-Rat ... B007JLN93S - it worked PERFECTLY
(First time I built a RepRap i tried to crimp by hand with pliers and whatever universal crimpl tool i had. Needless to say I fried 2 control boards - THIS time around I did it right - still have a few extras left over).
I suggest contacting support - maybe they have extra's to send.
(First time I built a RepRap i tried to crimp by hand with pliers and whatever universal crimpl tool i had. Needless to say I fried 2 control boards - THIS time around I did it right - still have a few extras left over).
I suggest contacting support - maybe they have extra's to send.
(No trees were killed to post this message, but a large number of electrons were terribly inconvenienced.)