Greeting to all...
Just completed my RMax & working on calibration.
Anyone using RAMBo v1.0e & printing successfully? Need correct firmware...
Thanx!
Hi from Melbourne, Australia
-
MorbidSlowBurn
- Printmaster!
- Posts: 169
- Joined: Sun Mar 03, 2013 5:33 pm
Re: Hi from Melbourne, Australia
Welcome to the forum.
I am still a little new also. What do you mean by printing successfully? I have been printing for a couple of weeks but am still tweaking to get better prints.
Because of variances there is no one perfect firmware setting as it needs to be adjusted for the tolerance changes in the setups. Genebs manual gives a starting point for getting decent prints including zeroing/leveling the machine.
After that it starts to become a learning experience. I recommend reading through mhackney's build thread on how he has gone through the process.
I don't know if there is a true difference between the firmwares but let us know which flavor you are using and describe the problem and I am sure people will chime in.
-Mike
I am still a little new also. What do you mean by printing successfully? I have been printing for a couple of weeks but am still tweaking to get better prints.
Because of variances there is no one perfect firmware setting as it needs to be adjusted for the tolerance changes in the setups. Genebs manual gives a starting point for getting decent prints including zeroing/leveling the machine.
After that it starts to become a learning experience. I recommend reading through mhackney's build thread on how he has gone through the process.
I don't know if there is a true difference between the firmwares but let us know which flavor you are using and describe the problem and I am sure people will chime in.
-Mike
Re: Hi from Melbourne, Australia
What is your RAMBo board revision?