Switch to 3mm?

[Jimustanguitar]

I was reading a post by lazerusrm earlier about how many of his problems were resolved by switching to 3mm filament ( http://forum.seemecnc.com/viewtopic.php ... ing#p13035 ).
Has anyone else done this and noticed an improvement? I've always considered the 3mm/1.75mm thing to be personal preference, but perhaps there's a practical difference too?

[cambo3d]

there are differences in extrusion pressure which also effects prints somewhat.. but I think it's really a matter of personal preference and setup. I've seen nice prints with both setups..

[lordbinky]

So it's like the difference between Godzilla and Mechagodzilla, both can destroy Tokyo just fine, it just depends which monster you want to fight?