Quick question, when I run the M303 E-1 S90 C3 my extruder starts heating up? Shouldn't the bed heat up with a E-1?
I already did a PID tuning for the extruder and want to calibrate my bed?
PID Tuning Heated Bed?
Re: PID Tuning Heated Bed?
E-1 is not the right code. Try P0/P1. Documentation here: http://reprap.org/wiki/G-code#M303:_Run_PID_tuning
If you have any trouble doing PID tuning, try this: http://forum.seemecnc.com/viewtopic.php?f=36&t=11440
If you have any trouble doing PID tuning, try this: http://forum.seemecnc.com/viewtopic.php?f=36&t=11440
Questions? Ask in a thread - PMs are off.
AI Calibration | Dimensional Accuracy Calibration | Hand-Tune your PID | OctoPi + Touchscreen setup | My E3D hot end mount, Z probe, fan ducts, LED ring mount, filament spool holder, etc.
AI Calibration | Dimensional Accuracy Calibration | Hand-Tune your PID | OctoPi + Touchscreen setup | My E3D hot end mount, Z probe, fan ducts, LED ring mount, filament spool holder, etc.