Auto Calibration with switch instead of accelerometer?

A place to talk about user-made mods and upgrades to their machines
Post Reply
Myshkin
Noob
Posts: 2
Joined: Wed Apr 06, 2016 7:42 am

Auto Calibration with switch instead of accelerometer?

Post by Myshkin »

Is it possible to use the latest seemecnc firmware with a simple switch on z_min as z-probe instead of an accelerometer? If so, how should it be setup in Configuration.h?

Thanks for any insights anyone may have!
Top
User avatar
mhackney
ULTIMATE 3D JEDI
Posts: 5391
Joined: Mon Mar 26, 2012 4:15 pm
Location: MA, USA
Contact:
Contact mhackney

Re: Auto Calibration with switch instead of accelerometer?

Post by mhackney »

Short answer, no.

Sublime Layers - my blog on Musings and Experiments in 3D Printing Technology and Art

Start Here:
A Strategy for Successful (and Great) Prints
Strategies for Resolving Print Artifacts

The Eclectic Angler
Top
Myshkin
Noob
Posts: 2
Joined: Wed Apr 06, 2016 7:42 am

Re: Auto Calibration with switch instead of accelerometer?

Post by Myshkin »

Thanks. I thought that might be the case from looking at a bit of the code. Just wanted to make sure I wasn't looking in the wrong spot or missing something obvious.
Top
Post Reply

Return to “Mods and Upgrades”