After updating to Repetier-host MAC 0.56 it suddenly all seems to work
No changes where made to the configuration file.... Just the SW update...Cheers!
/M
Search found 4 matches
- Tue Jul 30, 2013 4:18 pm
- Forum: Rostock MAX
- Topic: Extruder stepper motor does not work - why?
- Replies: 7
- Views: 4849
Re: Extruder stepper motor does not work - why?
Hi again!
After updating to Repetier-host MAC 0.56 it suddenly all seems to work No changes where made to the configuration file.... Just the SW update...
Cheers!
/M
After updating to Repetier-host MAC 0.56 it suddenly all seems to work
No changes where made to the configuration file.... Just the SW update...Cheers!
/M
- Tue Jul 30, 2013 3:04 pm
- Forum: Rostock MAX
- Topic: Extruder stepper motor does not work - why?
- Replies: 7
- Views: 4849
Re: Extruder stepper motor does not work - why?
Hi!
If I connect the extruder motor to one of the tower motor outputs it spins like a cat. So I think the wiring is correct.
If I plug in one of the tower motors into the extruder output it does not rotate...
Im quite stuck for the moment....
Thanks for your support so far!
/M
If I connect the extruder motor to one of the tower motor outputs it spins like a cat. So I think the wiring is correct.
If I plug in one of the tower motors into the extruder output it does not rotate...
Im quite stuck for the moment....
Thanks for your support so far!
/M
- Tue Jul 30, 2013 2:12 pm
- Forum: Rostock MAX
- Topic: Extruder stepper motor does not work - why?
- Replies: 7
- Views: 4849
Re: Extruder stepper motor does not work - why?
Yes I have it up at SET temp (tried different temp settings; that all seems to work well). The motor are though driving the gears forward at all. To me it seems to be a drive problem. If it is hardware or software I can't tell though... (the reason for me to upgrade the firmware before even test ...
- Tue Jul 30, 2013 11:38 am
- Forum: Rostock MAX
- Topic: Extruder stepper motor does not work - why?
- Replies: 7
- Views: 4849
Extruder stepper motor does not work - why?
Hi, Im setting up my IndigogoPerk-RostockMax (Yes very late!:)). Its the first time I touch a 3D printer and all that comes with it... Everything in the setup/calibration process (all movements of the delta arm etc) has worked good so far (updated Firmware to RepetierMAX 0.80 (and set what I think ...