Welcome to the SeeMeCNC Community

Scarring can be avoided using a 4mm z-hop or lift in your slicer setting. I use MC, Cura, or Kisslicer but havent paid for simplify3d so not sure where that setting is. I am curious if you tried running the delta cal wizard? I would suggest g29 three times, delta cal wizard, then g29 and print ...

I had extrusion width set to 100% last time I used Matter Control using MatterSlice engine. Honestly you are very close to having it calibrated and these results look great, grab some digital calipers and do a first layer test. Check if the thickness printed matches close your setting. The ...

I understand, didn't mean to say that you can't get good results stock, I was just speaking out of what I was experiencing and wanted more. There are plenty of other users that have stock and shown better results to make me eat my words :lol: https://www.seemecnc.com/pages/delta-calibration-wizard ...

Use three alternating bed clips, having 6 can cause more warping of the bed. Also make sure it is not too tight so watch when you secure it, make sure it doesn't push the bed down too much. I would do g29 three times, then the Delta Calibration. After you save the EEPROM settings I do another g29 ...

Hello, I have been trying to get a decent print out of my Rostock MAX V3 for almost over 3 weeks now but I am afraid I've failed miserably. I started off by calibrating my printer using the recommended steps in the assembly guide. First the simple calibration and then the advanced calibration using ...