Welcome to the SeeMeCNC Community

Hi Dale,

I have had a look at the EEPROM is it the Tower X endstop offset you mean? for Y and Z as well? These are all set to 0 in my settings.

Matt

Hi There, When I am doing a software calibration through matter control, on the second calibration point the nozzle wont move move downward toward the bed. Z height is registered as 4mm on the control page of matter control (I think it was 5 but I tried to move down 1 after the original movement ...

Hey there, I recently had a similar problem which in the end was due to my belts not being tensioned enough on the Z tower. This caused the belt to slip as the stepper tried to turn. Its a simple thing to try just in case. This was where I asked for help, there are other suggestions in there you ...

Thank you all for your suggestions. I ran this a couple of times and I think it was the Z tower belt was slipping during the downwards movement! causing the Z carriage to be in the wrong position at the start of the print. So I re-tensioned all the belts to be sure and slowed down that initial ...

Good evening everyone, Has anyone ever had this movement when printing the first layer? It only seems to happen when the peice is over a certain radius (doesn't happen on 50mm radius but does on 100mm radius disk for example.) https://www.youtube.com/watch?v=hBMQNsrtVmg&feature=share I was just ...

Ok Cool thanks both, So bear with me here, I'm new to this (and am using UK edition of parts) So if I want three layer fans, reckon I can butcher these for connectors?: http://www.ebay.co.uk/itm/10Pcs-12V-3Pin-Female-to-3Pin-Male-PC-Fan-Power-Splitter-Extension-Cable-Wire-K6-/291821652424?hash ...

Hi There, I've recently purchased an additional two layer fans for the rostock max. What is the best way of wiring these up? Can I just solder all three to the same wire from the rambo board or is it best to use a connector. Will I need a thicker wire to deal with the current draw from all three ...

Hey! I was looking at designing very similar things but yours look great! I will print these designs off and use them on my printer. Thanks!

Thanks

Hi there, I am wanting to machine an aluminium build plate for my rostock max V2. I was wondering what dimensions people used when they do these? Diameters and thicknesses. http://download.seemecnc.com/rostockmax/Rostock-MAX-v2-Assembly-Guide-4thEdition.pdf - and others has diameter as 300mm https ...