Welcome to the SeeMeCNC Community

Hey Guys, After probably 20 or so prints, I've encountered a problem I haven't seen before. Last night I was printing a round cylinder similar to shown below. After a seemingly uneventful start, I was in the other room and heard my Rostock Max v2 with an unusual sound, sort like it was rapidly ...

I just installed a new E3D v6 a few days ago w the .4mm nozzle on my Rostock Max v2. Running 1.75mm ABS at 228C. I've printed this filament before with the stock nozzle that came with the Max v2. I'm noticing when I've printed a couple of parts, they're came apart easily at the layers. I've printed ...

Welcome aboard... from West Palm I'm a newbie too; having gotten my Rostock Max v2 up and running only about a 6 weeks ago. Probably, calibration had the most to become more obvious after a few hours and asking several members here for help... which they did and I appreciate. I have to say the ...

Ok... please forgive me because I had this problem once before; solved it; but can't remember what I did.... Just installed my new E3D hotend and went to update Config.H on Repeteir.ino (Arduino 1.0.5r2). Can't get it to upload after is compiles. Have USB connected; Arduino shows its on Com4 ...

Hi guys.. I'm a Newbie; so please excuse... Just completed my R/S Max v2 and printed the fan shroud etc. Then a 20mm cube and noticed printer is printing with things leaning right. I made up a 25.4 x 25.4 x 50mm cube and printed it. Stopped it after a height of 20mm. See the two photos of cube ...

PARTIAL SUCCESS.... Well, after seeing WindShadow's reply; I loaded MC on the Mac and tried once again to have it find the printer. After some trials, I worked. Just knowing someone else was running on MC on the Mac and Yosemite at least gave me the confidence to keep trying. MC is recognizing the ...

dave perhaps one tow many emulations? i use a 2009 vintage macbook pro running Yosemite with my printer and after a bit of head scratching involving connect disconnect i is working just fine on OS X and Mater control roll it all back to square one use the older version of ardunio (the current one ...

Ok... after successfully builiding my R/S V2, I'm sadly having frustrating problems trying to get either MatterControl (MC) or Repetier (RP)to connect to it. I'm running a MacBook Pro with Parallels to run Windows 7.1. I loaded the firmware onto the printer using Arduino 1.0.5 in Windows seemingly ...