Welcome to the SeeMeCNC Community

I thought I'd post a little update... I did follow geneb's advice and set my DELTA_SMOOTH_ROD_OFFSET to the average of the three on my printer but that didn't seem have much of an effect. I decided maybe there is something causing the arms to be a little stiff, so I went over each moving piece with ...

Thanks Barnett for the offer to print my gcode to see the result on your printer, that will be useful to make sure the gcode is not the problem and the trouble lies somewhere else. But for now I'll try Geneb's recalibration ideas and hopefully I'll have similar results to his. Thanks Geneb for the ...

Hi All, Just a note, I'm using Cura for my gcode for the last couple of days since it makes a better (more legible) slice then slic3r does on small letters & numbers. Cura uses skeinforge for slicing, and I was looking closer at my gcode and I noticed my extraction speed in my gcode was F6000!! This ...

Hi All, I got my Max a few weeks ago and I'm having a lot of fun with it. I just thought I'd chime in here and say that I too am having the same problem. :( It's nice to know I'm not alone. I've tried all of the suggestions here so far and I still have the same problem. I've even started looking at ...