Welcome to the SeeMeCNC Community

I'm using matter slicer, and that's a great idea!

In my case it just stopped dead, the LED screen said "Killed". That's probably what you would prefer. I didn't need to print anything else so I just left it there. I dug into the Gcode and I found it was easy to find the line where it stopped, "slice266" and the code goes on from there. If I was ...

I have on a couple occasions found that my print stopped dead in its tracks saying it disconnected. From matter control Thinking it was just an error or glitch I just restarted and kept better eye on it and all was well. The last time I realized that it is probably the computer security bumping me ...

So tried the autotune again and as suspected it timed out because it never hits (or even comes close to) the target temp. The bed is pretty hot, but the temp reading never fluctuates beyond about 16-17.

Then I think it must be something in the Arduino settings. But I have no idea what to check. Maybe I'll try the PID autotune for the bed again, but I got a failure the last time so that told my nothing other than...what, there's a problem somewhere?

Ah, that changes things. Switched to the 200k setting I get a reading of 98.3 which I think is right.

Thanks for the welcome, glad to be here. I don't really understand the readings I'm getting when I put a multimeter on the thermistor. I took the bed up and poked around the underside checking for a short and measuring resistance. I checked the resistor and it gives me 4.7k as it should, but the ...

First post here, cheers. I've just finished the build on a V2 Max machine and all seems well except the bed temperature reading never gets past 16.7, even though the bed is hot. The temp reading at room temp gives me about 12.6, so that might be right. The hot end seems fine. If I manually set the ...