Welcome to the SeeMeCNC Community

mhackney wrote:Read my DropLit build thread - from a few weeks ago. I don't have access to it right this minute. Basically this is setup in Creation Workshop the printer config tab in the upper left side. The meaning of X and Y scale is not quite intuitive.

thanks! i´ll try it!!

http://i.imgur.com/C4WAlAE.jpg
how do i fix this? the layer height is 0.1mm, and the total amount of layers is 142, and the 3D print is the right height, according to the z axis configuration, and my ruler!

Hi Geneb! When do you think you'll have the last part of the manual ready?

I will post manual comments as I go through the build. Fig 3-6 shows the left side (with hinge holes) but figure 3-7 shows the partial assembly with the right side connected - if you follow the directions from 3-7 on - you will end up with the hinge side on the right - as I did ;-)) Hi! I had the ...

I guess I just have to wait then unless someone comes up with a quick guide!

Hi! I just bought this kit, and it's about to become my first printer, (still waiting for it to ship though). But I would like to know how to calibrate the z-axis, since I haven't found any information about the calibration process. I'm not very familiar with the software either. Thank you in ...

Thanks, i'll read it later!!! Can't Wait for my droplit!

I bought this, http://www.muve3d.net/press/product/qsi ... tomer-kit/ still waiting for the shipping, but I think this will get the job done

Hi! I just bought this kit, and it's about to become my first printer, (still waiting for it to ship though). But I would like to know how to calibrate the z-axis, since I haven't found any information about the calibration process. I'm not very familiar with the software either. Thank you in ...