Welcome to the SeeMeCNC Community

So many great replies! I should have soldered a blade fuse to get things moving as nitewatchman suggested. However i was patient and awaited my mouser order. They arrived today and i popped the fuse into the F2 slot. Entered the M119 command and haven't looked back. Thank you guys! This probably ...

So here is the update guys. I re-installed the firmware with a fresh download, still no z movement. Checked the three on-board fuses that i found, the lower one, just above the large on board capacitor is reading open. Oh, here is the RAMBo schematic, apparently this is the F2 Motor fuse :) Pretty ...

Right on guys thanks! I'll try clearing the EEPROM and reinstalling the firmware again, thanks Jay. Eagle thank you for the info! I'll bust out the meter and check those fuses! What a great intro to 3D printing!

Hey guys and gals, my name is Jeff ans i'm from Oregon. Finished my RosMax2 build in just 17 hours. It seemed strange, but went quite smooth! However when I went to calibrate, I could not get any axis movement. I went through all the steps to calibrate, with not a single movement. The board fires up ...