Welcome to the SeeMeCNC Community

Thanks for your replies. I understand that setting the z calibration on the LCD menu should save the printer height to the EEPROM, but everytime i did it it would return a seemingly random number that was normally much larger than the truth. Eventually the procedure above worked but I may well be ...

Hello, and thanks for all your replies! I'm glad to say I've printed another part at higher temps (230/110) and there were no cracks. I did get a very flat base where the part was in contact with bed and slic3r had some trouble where there were thin walls (see pics). Here are my settings: filament ...

Hi, Thanks for the reply.

I'm using 218 for the first layer and 220 thereafter. And auto-cooling was on.

If I turn off the fan for the entire job and raise the temp to 230 will it not overheat? I'll sure give it a try because the last print was awful!

Hi! I struggled for a couple of days with the Z callibration on the Orion but have now determined the correct procedure after reading the Rostock documentation (Rostock MAX Assembly Guide). Here is what I believe to be the correct procedure: 1. Preheat the nozzle and bed to your material's settings ...

I'm getting a lot of cracks in ABS.
Is there any ABS troubleshooting cracks information for Orion that I should refer to ?