Welcome to the SeeMeCNC Community

Thanks IMboring25 and Tincho85. I got it working.

Ill check that thanks

Ok so im lost the hotend will get up to the temp I have set 210. And then about 10 mins into the print it will start going down. last print it got down to 175 before I quit the print. does anyone have any ideas.

I thought about doing that but then saw this post. Hi TFMike, First, your issues are not machine calibration issues. All of that is done here at the plant. Next, the shipping companies are rough on everything. Leveling adjustment is performed by adjusting the three carriage screws. Adjusting the ...

Well here's my problem. The left side is always higher it's a good line. But the right will almost look clear. I've used a level to make sure the machine is level. Reset the z height a few times the best I can get is a good line on the right and then it lifts off on the left. The printer is a orion ...