I'm good thanks. That part is finished.
I'm past that and at the stage where I need to fine tune my e-steps so my prints don't look like shredded wheat.
Search found 4 matches
- Mon Feb 17, 2014 7:32 pm
- Forum: Troubleshooting
- Topic: Problem with Printer_Radius!
- Replies: 14
- Views: 10337
- Sat Feb 15, 2014 11:09 pm
- Forum: Troubleshooting
- Topic: Problem with Printer_Radius!
- Replies: 14
- Views: 10337
Re: Problem with Printer_Radius!
...erm....edit.... meant "edge" position, not "corner" (circles don't have corners)
- Sat Feb 15, 2014 11:04 pm
- Forum: Troubleshooting
- Topic: Problem with Printer_Radius!
- Replies: 14
- Views: 10337
Re: Problem with Printer_Radius!
I think a sentence needs to be added to Page 174 of the RostockMax Assembly guide since I got stuck here as well :? Once you've uploaded the new firmware, you'll have to re-calibrate the base of each tower as you did in the previous steps using Scripts 1 through 4. The parameter effects the ratio of ...
- Wed Jan 08, 2014 8:22 pm
- Forum: New Member introduction
- Topic: Hello from Nashville
- Replies: 1
- Views: 1836
Hello from Nashville
Hi guys 
. Not sure what to say for my intro.
I'm in the process of assembling the Rostockmax diy kit, and joined to keep from getting stymied as I go through the build. This will be my second printer - my first being the RepRap Prusa.
. Not sure what to say for my intro. I'm in the process of assembling the Rostockmax diy kit, and joined to keep from getting stymied as I go through the build. This will be my second printer - my first being the RepRap Prusa.