Welcome to the SeeMeCNC Community

HOw do you judge the speed of your printing....

What is standard so to speak? 20mm/s 15mm/s 30mm/s

I would like to print faster but it seems when I do I starve the filament...is there a way to set a balance.

for 30mm/s your filament rate should be x% or at minimum 30mm/s.....

etc

Thank you all for the information. It has been very good, I am working on getting smaller prints to work as it seems the larger ones are good for now. Or at least until I get my new arms.

I am going to try some smaller stuff and post here for feedback.

Thanks again for your time and input.

When I calibrated my bed height I had to turn my EEPROM of and use the arduiono software to make some changes for my bed. It though that it was concave. I made the adjustments with the EEPROM off and then had to turn it back on. I had to make a minor adjustment but not much. Then I turned it back on ...

626pilot
Thanks for the response and no I did not recompile my firmware with my EEPROM on. Should this be something that I change to make my prints better?
I have the latest version of Rambo.

cope413 Thanks so much for your input. 1. I have gone thru the extrusion calibration and it was very close. I will follow up on it again and see if I can get it even closer. 2. I will try my next print with the slower speeds and a heated bed to see what I get. I will keep you posted. You said that ...

Something else to note as well, I seem to be having a ton of trouble with small parts. I have the 0.5mm head on the printer, will it help a lot if I go to the smaller head before printing the smaller parts? It seems like it shouldn't matter..

So for temps I am really confused. I started out at 185, 190 but I was having a problem getting the first layer to stick to the print bed with glass or tape. So I was told to increase the temps to make it stick better. I am having a hard time with the settings because I am not sure what looks good ...

Hello all I have been lurking here on the forum quite abit in the last few weeks. I just got a RostockMax two weeks ago and have been having quite a few problems getting it to be consistent and need some help with getting the setup right if you can give me input. So far here is what I have been ...

thanks!

just got a rostock max, put it together in a couple of days, having a lot of problems...... mostly with extrusion. some with infill. any help?